CUTTING TROUBLE

[DEANS AUTO & CYCLE REPAIR]

WHAT SHOULD THE CUT SPEED BE ? I HAVE A GX-24 AND YOUR STENCIL KIT .

[Palepainter]

I have no problem with the stencil at the default cutting speed which is set at 20cm/s at this time. The weight has been more of the concern cutting it. We use a 60degree blade when cutting the material. Also the weight or force is between 180-220 depending on how new the blade is.

Welcome to the forum.

[bob mc]

I'm having a bit of a problem with my GX-24 Corel plugin.

It is erroring out saying a tmp file is wrong when I try to use the plug-in from inside Corel.

I remembered reading that Mike copies from corel and pastes into Cut Studio so that is what I did. That worked.

So far just practising cutting the black vinyl included with the cutter. It has pulled up the inside of some script lower case "s" es using brush script...so I'll need to figure out what to change to stop that, but it was still very nice. Nothing i could do by hand :)